Lantronix LTR16T, Installation Manual

Page: 10 / 36

4 LTR-T Installation Guide
Installation of Other Hardware Components
Ensure that the 10BASE-T (UTP) cables you will be using have been tested and labeled.
See the cable pinouts in Appendix C, if necessary.
If you will be connecting the LTR-T to a Thinwire segment, you will need an LTX-2 or
equivalent 10BASE2 transceiver to attach the segment to the LTR-T’s AUI port.
If connecting to a Thickwire segment, an LTX-5 or equivalent 10BASE5 transceiver will
be required as well as an AUI cable of the necessary length.
If you will be connecting the LTR-T to a Local Network Interconnect (DELNI or
equivalent) you will need an AUI cable between the DELNI and the LTR-T’s AUI port.
Checking the Cable Connections
Make sure you have enough cable to connect the LTR-T to your network. There are three
types of cable connections you must consider:
• 10BASE-T (UTP) segments: one or more, each up to 100 meters long.
• Power: outlet should be within 1.8 m (6 ft) of the LTR-T.
• AUI cable: up to 50 meters if going directly to a transceiver, or 45 meters total if
using a Local Network Interconnect (LNI) device. Consult your LNI manual to
verify the latter value.
Unpacking the Unit
As you unpack the LTR-T, make sure the parts listed in Table 2 are enclosed. If you have
not received a complete LTR-T unit, contact your dealer immediately.
Description of part Quantity
Multiport Repeater (LTR-T) 1
U. S. power cord 1
This manual 1
Table 2: Parts List