Lantronix LSS2200-8P, Install Manual, Page: 8 / 47

Lantronix LSS2200-8P Install Guide
33860 Rev. A https://www.lantronix.com/ 8
Specifications
Standards
IEE 802.3 (Ethernet), IEEE 802.3u (Fast Ethernet), IEEE 802.3z (1 Gig Ethernet,)
IEEE 802.3ae (10GE), IEEE 802.3af/at/bt (PoE), IEEE 802.1Q (VLANs), IEEE
802.1AB (LLDP), IEEE 802.3x (flow control), IEEE 802.1w (Rapid Spanning Tree)
Network Interface
•
Protocols: CSMA/CD
•
Full line rate non-blocking architecture
• Connectors: (8) 10/100/1000Base-T PoE++ ports, (2) 10G/5G/2.5G/1G SFP+ slots,
(1) Console RJ-45 port, (2) Digital Input/Outputs w/12VDC power output
•
MAC Address: 16K MAC address table
• NFC (coming soon)
• BLE
Data Speed
TP : 10/100/1000Mbps
SFP+ : 1G/SGMII/2.5G/5G/10G (SGMII for future use)
10/100/1000Base-T
Twisted Pair Port
Connector: RJ45
MDI/MDI-X selection: Automatic
Cable specification: CAT5 UTP or better (CAT6 recommended)
Fiber Ports
Connectors: SFP+
Power: Level III 2.0W (SFF-8419, Rev 1.3)
Modes: 1000Base-X, SGMII, 2.5GBase-X, 5GBase-X, 10GBase-X, USXGMII
RJ-45 Console port
CLI port
Cisco BLUE cable compliant pinning
MAC Addresses 16K MAC address table
Frame Buffer Memory 2 megabits per second
Dimensions
Width: 3.313’ [84.14 mm] x Depth: 5.125”” [130.18 mm] x Height: 7.145” [181.48 mm]
DIP Switch
#1 - Enable/Disable PHO to PoE-Power interlock (see Note)
#2 - Input 1 relay normal state (not active)
#3 & 4 - PoE power down selection
Note : for future use; the current default is disabled - do not change. (PHO is Disabled
by default; do not override until fully supported).
Reset button Reset the switch, Restore Factory defaults
DI/DO
Two programmable Digital I/O with 12V power output. Digital I/O can be used for
dedicated PHO (PoE Hardware Override) to turn on or off banks of PoE ports in
response to an external DI event (future release). ( Note : PHO is Disabled by default;
do not override until fully supported).
LEDs
RJ-45 TP port LEDs, SFP Fiber port LEDs, System LEDs, and LTE, Wi-Fi , SIM, and
USB LEDs
Weight 2.9 Lbs. / 1.3 Kgs.
Power
• Input 46-56VDC redundant power inputs:
•
46VDC for IEEE 802.3af
•
52VDC for IEEE 802.3at
• 54VDC for IEEE 802.3bt
• Maximum Power Consumption: 750 Watts with full 802.3bt 90W load on all ports