Lantronix
LSS2200-8P Install Guide
18
Mounting Options
Note for all mounting options
: Do not block air vents. A minimum of 1 inch clearance is required on all sides of
the unit when mounting either vertically or horizontally. Do not stack heat-dissipating objects on top of the unit.
Adequate clearance is required to access cable connections. Clearance is required to attach and mount the unit
regardless of the mounting option used (DIN rail, desk or shelf, wall mount, etc.).
Mounting the Switch on a Table, Desk, Shelf or Other Flat Surface
Four adhesive-backed rubber feet are included in a poly bag. Remove them from the poly bag, remove the
protective adhesive covering, and place the rubber feet as required.
Mounting the Switch on a Wall
A wall mount bracket kit (WMB-LSS, optional, sold separately) with two 4-40 x 1/4 screws included which can be
used to attach the bracket to the switch. Note: Due to variation in mounting surfaces, mounting screws not
provided.
A drawing of the bracket is shown below.
When mounting on a wall or other flat surface:
1. Consider device weight, grounding, power, cable limitations, wall structure, and suitable antenna location
ahead of time. Note that the minimum of 1 inch clearance is not required if shelf mounting using the rubber
feet.
2. Verify that the surface is sturdy and reliably grounded.
3. Attach the four adhesive rubber feet to the bottom of the switch.
4. Have appropriate screws on hand for mounting to desired type of wall surface.