Lantronix LSB4, Installation Manual

Page: 71 / 91

LSB4 Installation Guide Updating LSB4 Software
E-7
Introduction
Updating
LB Software
Updating
LSB4 Software
Updating the LSB4 using BCP
The Boot Configuration Program enables a user to configure the LSB4 in
the following situations: when the LSB4 fails during initialization, or when
an Initialize Noboot command is entered.
BCP commands are entered at a terminal connected to the serial console
port. (No additional software is required.) The following BCP commands
may be used:
♦
Help:
Displays a one page summary of the BCP commands.
♦
Init 451:
Re-initializes the LSB4. Use this command after other
configuration commands have been entered.
♦
Set System Hardware
xx-xx-xx
:
Specifies the LSB4's base hardware address. xx-xx-xx is the last
three bytes (hexadecimal characters) of the switch's Ethernet
address; the first three bytes will be supplied automatically. The
addresses of the other LAN ports are automatically computed
from this base address.
♦
Set System IPaddress address :
Specifies the LSB4's IP address. address must be entered in the
following form:
nnn.nnn.nnn.nnn
where
nnn
is a decimal number
from 0 to 255.
♦
Set System Loadhost:
The LSB4 will check this host address when attempting to load the
LSB.SYS file.
address
must be entered in the following form:
nnn.nnn.nnn.nnn where nnn is a decimal number from 0 to 255.