NetWare Host Troubleshooting
NetWare Configuration
5-4
5.5 NetWare Host Troubleshooting
Table 5-1: NetWare Host Troubleshooting (Bindery Mode)
Area to Check
Explanation
The print server names in PCON-
SOLE match the EPS name and its
service name
Use PCONSOLE to check.
The EPS NetWare access table
Use the Show Protocols NetWare Access command.
Scanning too many file servers can cause a delay
between jobs. Configure the access list to only scan for
jobs on the file servers of interest.
Table 5-2: NetWare Host Troubleshooting (NDS)
Area to Check
Explanation
The EPS NetWare access table
Use the Show Protocols NetWare Access command. By
default, only local file servers are scanned for queues.
The EPS login password and the
queue password on the file server
The passwords must match or the EPS will not be able to
log into the file servers to scan for jobs.
The EPS has successfully attached to
the queue
Type NETSTAT at the Local> prompt. This will display
information about fileservers, printers, and queues that
the EPS has found. If a queue is in JobPoll, the EPS has
successfully attached to the queue.
The DSTree, DSContext, and
DSLicense
Type Show Protocol NetWare NDS. This command
shows the tree and the context that you have configured, a
failure code, and an NDS error code for each server.
DSTree is the directory service tree on which the EPS is
located. DSContext is the context where the EPS is
located; it must match the context on the file server (The
DSContext must be of the following form:
ou=fruit.o=exotic). DSLicensed should be yes.
Printer and queue changes have prop-
agated through the NDS tree
It may take a few minutes for the changes to propagate. If
the EPS doesn’t attach, reboot the EPS.
