Configure
3.4.2 Using the Serial Port
If you want to initially configure the unit through a serial connection, follow these steps:
r PC running a
emulation prog
your unit's
ttings a
, 8 bits, no
, 1 stop bit, no
e
nd back on
ter power-up,
nostic L
nking.
You have one second
to
minal (or
up the unit.
. To
-10.
3.5 Server Configuration (Network Configuration)
8. Connect a console terminal o
terminal
ram to
serial port. The default serial port se
re 9600 baud
parity
flow control.
9. To enter Setup Mode, cycle the unit's pow r (power off a
). Af
the self-test begins and the red Diag
ED starts bli
enter three lowercase
x
characters (
xxx
).
Note: The easiest way to enter Setup Mode is to hold down the x key at the ter
emulation) while powering
10. At this point, the screen display is the same as when you use a Telnet connection
continue with a serial port login, go to
Using a Telnet Connection
on page 3
T
s basic network parameters. The following parameters are displayed when
y
ation
.
.(000) .(000
Set Gateway IP Address (N)
r of Bits for Host Part (0=default) (00)
config password (N)
Methods of Assigning the
2-3
ation about IP addressing.
3.5.2 Set Gateway
T
ress, o
s communication to other LAN segments. The gateway
address should be the IP address of the router connected to the same LAN segment as the
unit. The gateway addr
hese are the unit’
ou select
Server configur
IP Address : (000) .(000)
)
Netmask: Numbe
Change telnet
3.5.1 IP Address
he IP address must be set to a unique value in your network. See
T
IP Address
on page
for more inform
IP Address
he gateway add
r router, allow
ess must be within the local network.
3-12
CoBox-FL User Guide
Summary of Contents for CoBox-FL
