11
port is 1000MFD.
4.2
Back Panel
The back panel of the switch is configured as follows:
Figure 4-2 LP-SGW2404FP Back Panel
Grounding Terminal:
The switch already comes with lightning protection
mechanism. You can also ground the switch through the PE (Protecting
Earth) cable of AC cord or with Ground Cable.
Power Socket:
Connect the female connector of the power cord here,
and the male connector to the AC power outlet. Please make sure the
voltage of the power supply meets the requirement of the input voltage
(100-240V~ 50/60Hz).
4.3
Note
The surface on which the switch is placed should be adequately secured
to prevent it from becoming unstable and/or falling over.
Ensure that the power source circuits are properly grounded.
Ensure that the power cable, extension cable, and/or plug is not
damaged.
Ensure that the switch is not exposed to water.
Ensure that the switch is not exposed to radiators and/or heat sources.
Do not push foreign objects into the switch, as it may cause a fire or
electric shock.
Allow the switch to cool before removing covers or touching internal
equipment.
Use the switch only with approved equipment. If the switch is connected
to other network device with UTP cable, ensure the cable is not more
than 100 meters length.
