www.lanpro.com
Wireless - Equipment - 2.4 GHz - LP-1521 User Manual High Speed Long Range Wireless Broad Band Router, with PoE
13
Wireless - Basic Settings
This page is used to configure the parameters
for wireless LAN clients that may connect
to your Broadband Router. Here you may
change wireless encryption settings as well
as wireless network parameters.
Figure 13
Screen snapshot – Wireless Basic Settings
Item
Description
Disable Wireless LAN Interface
Click on to disable the wireless LAN data transmission
Band
Click to select 2.4GHz(B) / 2.4GHz(G) / 2.4GHz(B+G)
Mode
Click to select the WLAN AP / Client / WDS / AP+WDS wireless mode.
Site Survey
The
Site Survey
button provides tool to scan the wireless network. If any Access Point or
IBSS is found, you could choose to connect it manually when client mode is enabled. Refer to
3.3.9 Site Survey.
SSID
It is the wireless network name. The SSID can be 32 bytes long.
Channel Number
Select the wireless communication channel from pull-down menu.
Associated Clients
Click the Show Active Clients
button to open Active Wireless Client Table that shows the
MAC address, transmit-packet, receive-packet and transmission-rate for each associated
wireless client.
Enable Mac Clone (Single Ethernet
Client)
Take Laptop NIC MAC address as wireless client MAC address.
[Client Mode only]
Enable Universal Repeater Mode
Click to enable Universal Repeater Mode
SSID of Extended Interface
Assign SSID when enables Universal Repeater Mode.
Apply Changes
Click the
Apply Changes
button to complete the new configuration setting.
Reset
Click the
Reset
button to abort change and recover the previous configuration setting.