Lanner V3S, User Manual, Page: 3 / 69

V3S User Manual
3
Compliances and Certification
This product has passed the CE test for environmental specifications. Test conditions for passing included
the equipment being operated within an industrial enclosure. To protect the product from being damaged
by ESD (Electrostatic Discharge) and EMI leakage, we strongly recommend using CE-compliant industrial
enclosure products.
This equipment has been tested and found to comply with the limits for a Class A digital device, according
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used following the instruction manual, may
cause harmful interference to radio communications. The operation of this equipment in a residential area
is likely to cause harmful interference, in which case the user will be required to correct the interference at
his own expense.
EMC Notice
This equipment has been tested and found to comply with the limits for a Class A digital device, according
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used following the instruction manual, may
cause harmful interference to radio communications. The operation of this equipment in a residential area
is likely to cause harmful interference, in which case users will be required to correct the interference at their
own expense.
Safety Guidelines
Follow these guidelines to ensure general safety:
Keep the chassis area clear and dust-free during and after installation.
Do not wear loose clothing or jewelry that could get caught in the chassis. Fasten your tie or scarf and
roll up your sleeves.
Wear safety glasses if you are working under any conditions that might be hazardous to your eyes.
Do not perform any action that creates a potential hazard to people or makes the equipment unsafe.
Disconnect all power by turning off the power and unplugging the power cord before installing or
removing a chassis or working near power supplies
Do not work alone if potentially hazardous conditions exist.
Never assume that power is disconnected from a circuit; always check the circuit.