Chapter 4:
Hardware Setup
Preparing the Hardware Installation
To access some components and perform certain setup,
please read the warning below before installation procedures.
WARNING:
To reduce the risk of personal injury, electric
shock, or damage to the equipment, please power
off the system and remove all power connections.
Please wear ESD protection gloves before
conducting the following steps.
1. Make sure LVC-2001 is powered off and disconnected from
any power source.
2. Turn the device upside-down.
3. Remove the 4 screws circled in the image below.
4. Apply force at the opening notch to lift the compartment.
Installing Memory Module
1. Locate the DDR socket on the motherboard.
2. Insert the DDR module to the socket. Make sure the
notches are aligned.
3. Press the module down and the latches will clip on
the module.
Note: the system supports DDR3L SO-DIMM x1up
to 4GB memory. Please use memories within the
defined specifications to ensure proper operations.
Installing Full-sized Mini-PCIe Module
1. Align the Mini-PCIE module’s keys with the Mini-
PCIe slot (MPCIE1/MSATA1) notch.
2. Insert the module into the connector.
3. Press the module down and install the module
with screws.
