Chapter 3: Hardware Setup
To access some components and perform certain service procedures, you must perform the following
procedures first.
Warning:
To reduce the risk of personal injury, electric shock, or damage to the equipment,
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some
internal circuitry remain active until AC power is removed.
The system provides a total of six externally accessible LAN I/O blades and/or switch boards, varied
depending on ordering configurations (the system supports up to 2x switch boards and up to 5x LAN I/O
blades). To replace a new blade/board, please follow the steps below.
1.
Rotate and loosen the two captive screws at both ends. You may use a screwdriver to conduct this task.
2.
Pull the two locks towards the directions as shown in the arrows of directions below.
3.
Gently pull the board/blade out.
