Lanner FW-8759, User Manual

Page: 16 / 45

Clear CMOS and Disable ME Jumper Setting (J4)
:
It is for clearing the CMOS memory and system
setup parameters by erasing the data stored in
the CMOS RAM such as the system passwords.
The ME_disable setting allows updating the Intel
Management Engine firmware through software
without a electronic programmer. The Intel ME's
leverage of non-volatile storage prevents users
from removing critical inventory, remote control, or
virus protection agents.
To clear CMOS, disconnect AC power supply. Set the
jumper to 4-6 and wait a minute to be sure the
CMOS has been cleared. Then return the CMOS
jumper to it's original position.Restore power to
the system.
Bypass LED Function (J12)
Generation 3 Bypass Firmware Download Connector
(J7)
Generation 3 Bypass Program Selection Header (J8)
Hardware or Software Reset Jumper(J3) : The jumper
can be adjusted to be in either hardware or software
reset mode when the reset switch is pressed. The
hardware reset will reboot the system without
turning off the power. The software reset can be
programmed to reset a software to its default
setting.
ATX Power Connector(ATX1, ATX2)
: Find the proper
orientation when inserting the plugs, for the supply
plugs are designed to fit these connectors in only
one orientation.
AT/ATX Mode Selection Header (J13)
AT Mode Power Connector (CONN5)
Pin No. Signal Pin No. Signal
1 GND 2 +12V
3 GND 4 +12V
5 GND 6 +12V
7 GND 8 +12V
Pin No. Function
1-2 HW Reset
2-3 Software Reset
(default)
1
2
7
8
20
2
19
1
Pin No. Signal Pin No. Signal
1 +3.3V 2 +3.3V
3 +3.3V 4 -12V
5 GND 6 GND
7 +5V 8 PSON
9 GND 10 GND
11 +5V 12 GND
13 GND 12 GND
15 PROK 16 -5V
17 5VSB 18 +5V
19 +12V 20 +5V
3 2 1
1 2
Pin No. Signal
1 P3V3
2 MR#
3 1
4 2
Pin No. Signal
1 GND
2 GND
3 PWR_BTIN_N
4 PWR_BTIN_N
Pin No. Signal
1 GND
2 PSON-
2 1
1
3
5
2
4
6
Pin No. Function
1-3 ME_DISABLE
3-5 NORMAL
2-4 NORMAL
4-6 CLEAR CMOS
9
1
10
2
Pin No. Function Pin No. Function
1 NC 2 NC
3 NXP_RXD 4 NXP_RTS_N
5 NXP_TXD 6 NXP_CTS_N
7 NC 8 NC
9 GND 10 P3V3SB
Pin No. Signal Pin No. Signal
1 CPLD_LED1_L 2 CPLD_LED1
2 CPLD_LED2_L 4 CPLD_LED2
3 CPLD_LED3_L 6 CPLD_LED3
2 6
1 5
Pin No. Function
1 P3V3SB
2 CPLD_LED3
3 GND
1 2 3
Pin No. Signal Pin No. Signal
1 P3V3SB 2 NC
3 ME_DISABLE 4 RTCRST#
5 NC 6 GND