the name of the boot image. The client uses TFTP to download the
Network Bootstrap Program (NBP) from the Boot Server and then
initiates execution of the image (boots from the image).
Onboard
LAN1/LAN2/LAN3/LAN4
Control
Enable your LAN Controller
On board FDC Controller
Enable the onboard floppy controller. Select Enabled when you have
installed a floppy disk drive.
Onboard Serial Port 1
Select an address and corresponding interrupt for the first and second
serial ports. The settings are “3F8/IRQ4”, “2E8/IRQ3”, “3E8/IRQ4”,
“2F8/IRQ3”, “Disabled”, “Auto”.
Onboard Parallel Port
This item allows you to determine onboard parallel port controller I/O
address setting. The settings are “378H/IRQ7”, “278H/IRQ5”,
“3BC/IRQ7”, “Disabled”.
Parallel Port Mode
Select an operating mode for the onboard parallel (printer) port. Select
“Normal”, “Compatible”, or “SPP” unless you are certain your hardware
and software both support one of the other available modes.
ECP Mode Use DMA
Select a DMA channel for the parallel port for use during ECP mode.
The settings are “3” and “1”
3.7 Power Management Setup
The “Power Management Setup” controls the CPU card‘s “Green” features. When you select
the “POWER MANAGEMENT SETUP” on the main program, the screen display will
appears as:
Power Management Setup Screen
ACPI Function :
This item allows you to enable or disable the Advanced Configuration and
Power Management (ACPI). The settings are “Enabled” and “Disabled”.
Power Management :
