5/19/2021
www.lankota.com | Lankota Inc.
Page | 18
Lankota is a registered trademark of Lankota Group.
Shear Plates—Setup & Adjustments
•
Start with Plate 1 all the way out, Plate 6 all the way in and gradually stagger the rest
between them. (Plate 2 is 1/5 out, Plate 3 is 2/5, Plate 4 is 3/5 and Plate 5 is 4/5 out.)
•
If the grind is too fine, start at the top and pull the plates out until it is as desired.
•
If the grind is too coarse, start at the bottom and push the plates in until it is as desired.
Even when the plates are all the way in, the tips of the hammers will not be able to
contact the edge of the shear plates.
The cutouts on the side of the shear plates show the full range of adjustment.
1
2
3
4
5
6
