9
7.3
Mounting the bottom part of signal requesting device
Fig. 8
Fig. 9
The bottom part
(1)
of the device is
pre-assembled with the steel lighting-
pole adaptor (protection against
vandalism)
(2)
and pole seal (flexible)
(3)
.
•
Take off the plastic caps (captive)
(2)
.
•
Fasten the bottom part
(1)
of the device
to the lighting pole with 2 M6x25
fastening screws.
•
Note:
- Torque approx. 5 Nm.
- Check that the signal requesting
device fits correctly on the lighting
pole.
•
Put on the plastic caps (captive)
(2)
again.
Note: Check for correct fit.
(Protection class!)
•
Connect the connection cable to the
cable distributor according to the block
diagram in chapter 4.7.
•
Unused cores must be insulated.
A function test must be carried out
when the pedestrian signal requesting
device has been installed!
1
2
2
3
1
