- 70 / 79 -
LANGER
EMV-Technik
DE-01728 Bannewitz
[email protected]
www.langer-emv.de
FLS 106 IC set / FLS 106 PCB set
Connecting a Near-Field Probe Directly to the FLS 106 PCB Scanner
18.2.1
If operated without a pre-amplifier, the RF measuring cable has to be connected to the near-field
probe's measurement output and directly to "RF in" input on the scanner's Z-axis tower
(Figure 105).
Figure 105: Connecting the respective RF measuring cable to the near-field probe and the "RF in" connector on the Z-
axis tower
Connecting a near-field probe with a pre-amplifier
18.2.2
Note: The selection of the correct pre-amplifier depends on the measurement task and the near-
field probe used. Please contact us should you have any queries (chapter 24).
Connect the pre-amplifier's SMA output to the "RF in" input on the scanner's Z-axis tower
(Figure 106).
Figure 106: Pre-amplifier on the scanner's "RF in" input
Connect the near-field probe's RF measuring cable to the pre-amplifier's SMA input (Figure 107).
Connect the pre-amplifier's power supply cable to the "12 V DC" connector on the Z-axis tower
(Figure 108).
