Section D
Lifting your top and
Storage
1. Before you lift your top Test
all connections make sure
hardware is secure in the
ceiling and bolts are tight
.
2.
Back your jeep into the lifting
position . The rear Smart Hook®
should hang in the middle of the
window and barely touches the
glass.
3.
Release all hardware holding
down the hardtop and remove
the Freedom Top® panels. Take
care to unplug your wiring
harness in the back of the jeep.
4.
With one hand or with the help
of a friend, by the rollbar at the
top, slightly Lift one front corner
of your top and slide the lifting
strap in between your top and
the body of the Jeep. Slip the
grommet over the elevator bolt.
Hand tighten the wing nut To
hold the strap in place. Repeat
on the other side. *note the 2
door will use the second set of
holes in from the door see page
6 to locate proper holes*
5.
Open your rear window and put
the year appropriate hook
between the glass and your top.
Carefully close your rear window.
6.
Turn your crank clockwise to
begin lifting your top.
7.
You may need to adjust the
length of the cable attached to
the Smart hook®, or to the lifting
strap by loosening the wire
clamps and adjusting the length
of the cable.
8.
Do not over lift your top and put
undue pressure on the pulleys.
Call toll free 1-866-284-7428
Langeoriginals.com
Copyright Lange Originals
8
