Section B
Pulley installation
Determine if your studs run
perpendicular or Parallel with
your garage door. If your
studs run perpendicular to
(or the opposite direction as
your garage door) please see
section D.
1.
With the mounting
screws provided, mount
the double pulley and
one of the single pulleys
in the center of your 2x6.
2.
Mount the second single
pulley ½ inch left of
center on the 2x6. This
will allow the second
cable to run along the
ceiling without
interfering with the other
cable.
3.
Mount the 2x6 with the
double pulley in the top
corner of the wall or the
ceiling directly above the
crank unit. See page 6
4.
Measure the distance
from the wall to the back
of your jeep where you
plan to lift the top.
Mount the 2x6 with the
single pulley centered at
this point. (this will be
the rear of the Jeep or
the hook side) see page 6
5.
From the center of the
middle 2x6 measure over
34 inches and install the
2x6 with the single pulley
that is left of center. (This
will be the strap side)see
page 6
Call toll free 1-866-284-7428
Langeoriginals.com
Copyright Lange Originals
•
Hint:
•
It may be easier to put in the screws when the wheels
are removed
5
½ inch left of center
Wall or ceiling
First ceiling pulley
Second pulley
