TOP
A
HOIST
®
Frame Assembly
A. Locate the Metal T-Frame Bundle. Slide two of the support arms (HAT-101) into the T-shaped bar
(HAT-100) moving the spring button to the appropriate holes as shown in Fig. 3
B. Slide the Black Foam Holes (HAT-018) on the arms (HAT-101) to protect your hardtop and freedom top
pieces. The black round foam pieces should be spaced directly under your Freedom Top Panels during
storage.
C. Slide the JL Foam Square Support (HAT-134) on the T-Shaped bar (HAT-100) over the lifting blade.
There is a slit that allows you to do this. Pay close attention to the direction of the JL Foam Square
(HAT-134) in Fig. 1, and orient it likewise.
D. Assemble long foam supports (HAT-135) just in front of the lifting blade (HAT-101) as shown in Fig. 2
E. Insert the remaining support arm (HAT-101) into the rear of the T-Shaped bar moving the spring
button to the appropriate hole as shown in Fig. 4
F. Put the J-Shaped hooks (HAT-003) through the holes found on each end of the front support arms
(HAT-101). Place one hole of the grommet strap (HAT-110) around the threaded part of the J-Shaped
hook (HAT-003). Secure with the nylon nuts (HAC-015) to the point of only 3 threads past the nylon
part of the nut. Do not over tighten these hooks. We will go over JL Rear Hook installation in the
sections to follow.
G. Insert plastic end caps (HAC-028) to the end of each support arm (HAT-101).
Fig. 1
Exploded Diagram of
Frame Assembly
Fig. 2
Completed Frame
Assembly