![background image](http://html1.mh-extra.com/html/lang/rt36a/rt36a_installation-and-operation-instructions-manual_3618463011.webp)
11
2M-W1091, Commerical & Marine Electric Range T
op
2M-W1091, Commerical & Marine Electric Range T
op
MAINTENANCE AND CLEANING continued
Induction Troubleshooting
In the event of a possible malfunction your Lang Wave module will display an error code on the display.
See below when encountering an error code on your display. To reset error conditions remove the pan
from the unit and turn off power to the unit.
INDUCTION TROUBLESHOOTING
Symptom
Probable Cause
Possible Solution
No Power
(no lights or fan noise)
Power the unit, disconnecteed or
circuit breaker open.
Turn on main power switch, check
circuit breaker.
Pan does not heat
Pan is not induction efficient
Use induction efficient pan
Pan not centered
center pan
Unit suddenly stops
heating
Possible power brown out
Verify proper voltage/power
Safety shut-off engaged
The safety shut off will engage if
an empty pan is left on the cooktop
surface while the unit is working at
full power. Make sure the cooktop
surface is clear. Wait 15-20 minutes
for the unit to reset.
Pan heats unevenly or
over heats
Pan not unduction efficient
Use induction efficient pan
Pan bottom may not be flat
Use flat pan
Pan not centered
Center pan
Pan is less than 7” dia
Use larger induction efficient pan.
INDUCTION ERROR CODES
Error
Cause
Code
Troubleshooting
1
Broken Temp
Sensor
E-01
Service required to replace sensor
2
Glass Temp. to
high
E-02
Remove pans from surface & let unit cool. Turn unit power OFF & then ON.
If unit does not return to normal operation, service is required.
3
Over Current
E-03
Try different cookware, current may be required
4
Over heat or air
flow restriction
Air-Flow
Make sure air inlet vents in the rear are not restricted, listen for unit fan operation
6
Hig Line Voltage
E-06
To reset, turn OFF unit power & turn on again. Verify power line voltage.
7
Hardware Failure
E-07
Service required
8
Zero Cross
Failure
E-08
Turn OFF unit, then turn ON. If problem persists, service is required.