1
Before You Begin
Read these instructions carefully and completely.
•
IMPORTANT
—Save these
instructions for local inspector’s use.
•
IMPORTANT
—Observe all
governing codes and ordinances.
• Note to Installer—Be sure to leave these
instructions with the consumer.
• Note to Consumer—Keep these
instructions for future reference.
• Proper installation is the responsibility
of the installer and product failure due
to improper installation is NOT covered under
the warranty.
• NOTE—This appliance must be properly
grounded.
•
ATTENTION INSTALLER
All electric drop-in ranges must be hard wired
(direct wired) into an approved junction box. A
plug and receptacle is NOT permitted on these
products.
If you have questions, call 1.800.GE.CARES or visit our website at:
GEAppliances.com
Self-Cleaning Radiant
Electric Drop-In Range
Installation
Instructions
JDP47, JD968, JD900, PD900, PD968
Materials Needed
Junction Box
Wire Nuts
Strain Relief Clamp for
1/2” conduit
Parts Included
Lower Trim
4 Screws
2 Shoulder Screws (for
stop device)
Tools You Will Need
1/8” Drill Bit and Electric
or Hand Drill
Phillips Screwdriver
Nut Driver
Level
Tape Measure
Straight Edge
or Square
Hand or Sabre Saw
Standard Screwdriver
Pencil
Safety Glasses
Hammer
31-10622-3
02-10
Summary of Contents for PD900
Page 15: ...15 NOTES...
Page 16: ...16 NOTES 31 10622 3 02 10 GE...
