4
PROGRAMMING
PROGRAMMING SEQUENCE
The following procedure describes a standard programming sequence. Each programming prompt is shown
in the coloum DISPLAY and the required program entry is shown in the coloum ACTION.
The Control allows for a 3 second delay between each button push, if a delay of longer than 3 seconds has
occurred, the programming sequence must be re-entered.
ACTION
Press:
Read/Clear, 1, 6, 2, 7, 3, 8
Select a
Product Button
1 through 0
Enter a
Cooking Temperature
, 100 through 450 degrees.
Enter a
Cooking Curve
, 0 through 7. For a definition of Cooking curve, refer to
the
DEFINITIONS
section.
Select a
Fan Function
. 0 = Off, 1 = On. For a definition of Fan Function, refer
to the
DEFINITIONS
section.
Enter a
Cooking Time
, Hours/Minutes/Seconds up to 9:59:59.
This prompt is the beginning of the
Tier 2
portion of the programming. For a
definition of
Tiers
refer to the
DEFINITIONS
section.
If, during the cooking cycle, the program calls for a change in the
Cooking
Temperature
or
Fan Function
that change can be entered at this time.
The Tier being programmed is indicated by the lighted
Tier Lamp
below the
Display.
If Tier 2, Tier 3, or Tier 4 programming is required, repeat the above entries as
prompted by the display (Cooking Curve is entered in Tier 1 only ) until all
necessary Tiers are programmed, then proceed to the steps shown below.
IMPORTANT
If the program requires one Tier programming only
DO NOT
repeat the above
procedures, proceed to the steps shown below.
DISPLAY
EnTer
Prod
000 F
CC0-7
FAn 01
0:00:00
000 F
