Laney
6
Laney
The ENHANCE control provides an increased definition at the
low-end of the frequency spectrum giving you a tighter,
punchier sound. The ENHANCE control does this by providing
a dip in the frequency-response of the amplifier at
approximately 200hz.
This dip eliminates some of the
secondary-harmonics of the important low-frequencies around
40-80 Hz producing a thicker sound.
Turning the control
through to its maximum has the effect of boosting both the
low and high-frequency content of the signal whilst not
effecting the mids.
Selects the LO MID-frequencies to be cut or boosted in
conjunction with the
LO PARAMID LEVEL control (7). To
access
low LO mid-frequencies turn the FREQUENCY control
anticlockwise, to access higher LO MID frequencies turn the
FREQUENCY control clockwise
Sets the level of boost or cut applied to the frequency set by
control (6).
For frequency-boost turn the control
clockwise.
For frequency-cut, turn the control anti-
clockwise
Hi Paramid Frequency : Selects the HI MID-frequencies to
be cut or boosted in conjunction with the Hi PARAMID LEVEL
control (9). To access
low Hi mid-frequencies turn the
FREQUENCY control anticlockwise, to access higher Hi MID
frequencies turn the FREQUENCY control clockwise
Sets the level of boost or cut applied to the frequency set by
control 8. For frequency-boost turn the control clockwise.
For frequency-cut, turn the control anti-clockwise
Controls the high-frequency response of the pre-amplifier.
Allows the on-board limiter to be defeated if desired. With
the switch in the out position the limiter is engaged. The
limiter is automatically triggered at high-output levels
and is designed to prevent power-amp distortion at high-
output levels. When the limiter is autpmatically triggered
an LED lights up to indicate the limiter is active. It is
possible to have the limiter engaged but not have the LED
active.
The LIMITER monitors both power-amp clipping and
load so it automatically registers the cabinet-impedance and
sets itself accordingly.
Sets the overall listening level of the amplifier.
Switches the on-board horn either on or off.
XLR socket for direct-injection of the amplifier signal to a
mixing-desk or additional power-amplifier. The XLR socket
provides a balanced low-impedance output-signal.
Controls the low-frequency response of the pre-amplifier
4.Enhance:
5.Bass:
8. Hi Paramid frq:
9.Lo Paramid Level:
10.Treble:
11.Limiter:
12. Volume:
13.Horn switch:
14.D.I:
6. Lo Paramid frq:
7.Lo Paramid Level:
Richter
Summary of Contents for Richter R1
Page 1: ...Laney R1 R2 R3 R3H R4 R4H R5 User manual Richter Bass Amplification...
Page 14: ......
Page 15: ......