MAINTENANCE AND STORAGE
1. Charge the battery and leave it off of the unit. DO NOT leave the battery on the charger.
2. Remove the auger from the power head and apply a thin layer of grease to the drive shaft.
3. Remove all debris from auger and power head.
4. Attach the blade guard to bottom of auger.
5. When storing the battery for the off season, fully charge the battery, and store in a dry
location that maintains a temperature of 60-75 degrees F. To help maintain battery life,
charge battery for 10-15 minutes every two months. (Charger may show red after15 minutes
of charging. This is normal.)
NOTE: REMEMBER TO FULLY CHARGE BATTERY BEFORE FIRST USE OF THE
SEASON.
Lithium ion batteries can reach a point where they can no longer hold a charge and need to be
disposed of. Please recycle the battery at your nearest recycling center.
TROUBLE SHOOTING
E4
Problem
Power head will not run
Power head will not
start and the battery
indicates a full charge
Power head starts,
then stops
Auger jumps on ice
Auger cuts slowly
Auger head gets
stuck when drilling.
When drilling, the
unit stops working
after the beep.
When drilling, the
unit suddenly stops
workings without
any warning.
Possible Cause
1. Operating trigger is not
pressed completely.
1. Battery too cold.
1. Battery low on power
2. Battery may be slightly under
temperature
1. Blades damaged or
sharpened incorrectly.
1. Dull blades
1. It may hit big stocks or roots.
2. The load is too big when
pushing down too hard, so
that the overload protector
works to stop the unit.
1. The load is too big when
pushing down, so that the
overload protector works to
stop the unit.
1. The overload protector
works.
2. If only the red light is lit, it
means the battery capacity
is too low.
Solution
1. Press the operating trigger and
hold for 1-3 seconds.
1. Remove the battery from the
unit and place it in a warm
location (inside a jacket pocket,
vehicle or a small cooler with
a warmer).
1. Charge battery.
2. Remove the battery from the
unit and place it in a warm
location (inside a jacket pocket,
vehicle or a small cooler with
a warmer).
1. Replace with new blades.
1. Replace with new blades.
1. Take the rock or root out, or
drill in another place.
2. Reduce the downward
pressure and let the head
spiral drill down naturally.
1. Release all the triggers and
buttons, and try to operate after
3 seconds.
2. Reduce the downward
pressure and let the head
spiral drill down naturally.
1. Pull out the battery, wait for 3
seconds and insert it to try
again.
2. Charge the battery.
