1. Make sure your footing is secure and that you have the unit in the vertical position firmly in
your hands.
2. Press the operating lock button, then squeeze the operating trigger. Following a one-second
safety delay, the auger will then start drilling. (See Fig. 7)
3. To stop the auger, release the operating trigger.
4. If the auger is stuck or hard to be pulled out, try the reverse function. Press the Reverse
Button, then press the operating lock button and the trigger. The auger will turn in reverse.
After the auger is pulled out, release the operating trigger.(See Fig. 8)
5. When the auger is not in use, remove the battery.
IMPORTANT
DO NOT LEAVE BATTERY ON POWER HEAD WHEN AUGER IS NOT IN USE. ALWAYS
DETACH BATTERY WHEN NOT USING THE AUGER.
Battery Charging and Monitoring
1. Battery must be fully charged before first use.
2. Plug the charger into a 110-240AC outlet.
3. Always charge the battery at room temperature. If the battery is used in a cold environment,
allow it to warm up for at least an hour before charging. Cold batteries will not be charged
completely and battery components may be damaged.
4. Only charge battery in well ventilated area away from flammable materials such as cloth or
carpeting.
5. During the charging phase, the light on the charger will be red. When the battery is
completely charged, the light will turn to green.
6. To disconnect charger, remove the three-pronged plug from outlet, then disconnect the
charger from the battery.
7. DO NOT leave the charger being connected to the battery for more than 24 hours.
8. The battery status indicator is mounted on the top of the battery to allow you to observe the
level of the battery power while in use. When all the 3 green lights and 1 red light are lit, it
means the power is sufficient. When only the red light is lit, it means it needs to be charged
immediately.To check the charge level, simply press the indicator button.The lights on the
status indicator show the charge level of the battery.
9. When battery power becomes insufficient to drill through ice, turn off the power switch,
disconnect the battery from power head, and re-charge the battery. Do not further discharge
the battery beyond the point it cannot power the auger through the ice. Completely draining
the battery may damage the battery components and increase the likelihood of battery
malfunction, battery fire, or even explosion.
10. If battery becomes warm or hot during charging procedure, disconnect it from charger.
Allow battery to return to room temperature, and attempt to charge again. If this persists a
second time, disconnect battery from charger and contact customer service.
E3
Fig.7
Operating Trigger
Operating Lock Button
Fig.8
Reverse Button
Battery Status Indicator