Landoll WEATHERPROOFER II 2320 Series, Operator'S Manual

Page: 39 / 59

3-8 DISC GANG INSTALLATION
IMPORTANT
READ ALL SAFETY PRECAUTIONS AT THE
FRONT OF THIS SECTION BEFORE ATTEMPT-
ING ANY OF THE FOLLOWING PROCEDURES.
DANGER
DISC BLADES ARE EXTREMELY
SHARP. EXERCISE EXTREME CARE
WHEN WORKING ON OR NEAR DISC
BLADES. DO NOT ALLOW DISCS TO
ROLL OVER OR FALL ONTO ANY
BODILY PART. DO NOT ALLOW
WRENCHES TO SLIP WHEN WORK-
ING NEAR DISC BLADES. NEVER
PUSH WRENCHES TOWARD DISC
BLADES. DO NOT CLIMB OVER MA-
CHINE ABOVE DISC BLADES. FAIL-
URE TO STAY CLEAR OF DISC
BLADE EDGES CAN CAUSE SERI-
OUS PERSONAL INJURY OR DEATH.
3-8.1 FRONT DISC GANG INSTALLATION.
IMPORTANT
THE FRONT DISC GANG FRAMES ARE THE
SHORTER PAIR.
a. Install the pivot block on the outer disc gang
frame pivot so the long end is facing the rear
of the frame.
b. Hoist the disc frame up until the disc frame
arm goes into the inner mounting bracket on
the main frame. Locate the disc gang so that
the pivot block is behind the outer mounting
bracket.
c. Align the pivot block with the outer mounting
bracket and slide it forward.
d. Install a hitch pin through the inner mount-
ing bracket and the ball socket of the disc
frame arm. Secure with cotter pins.
e. Install a bushing in the outer frame bracket
by putting a 1" x 6" bolt up through the
bracket and a nut on the top.
IMPORTANT
MAKE SURE THE NUT IS ON TOP.
f. Two angle adjust pins are installed in the
outer mounting bracket with hair pins. Make
sure angle adjust pins are assembled as
shown in Figure 3-9. These angle adjust pins
are used to adjust the angle of the disc
gangs. (See Section 4-4.7).
3-8.2 REAR DISC GANG INSTALLATION.
a. Install the pivot block on the outer disc gang
frame pivot so the long end is facing the front
of the frame.
b. Hoist the disc frame up until the disc frame
arm goes into the inner mounting bracket on
the main frame. Locate the disc gang so that
the pivot block is in front of the outer mount-
ing bracket.
c. Align the pivot block with the outer mounting
bracket and slide it rearward into the bracket.
d. Install a hitch pin through the inner mount-
ing bracket, the ball socket of the disc frame
arm and the pivot spacer (See Figure 3-10).
Secure with cotter pins.
3-15
Figure 3-10 Pivot Spacer Block Installation