Landoll Tilloll 875 Series, Operator'S Manual

Page: 45 / 64

3-14 WARNING LIGHTS INSTALLATION
3-14.1 Assemble lights to the warning light
bracket using 1/4-20 X 1-1/4 hex head cap
screws and hex lock nuts. Insure the wires
are in the groove in the base of the light to-
ward the mounting surface on the bracket.
Assemble one light for left side and one for
right side. The red light should be to the rear
with the amber light being the outer most
light.
3-14.2 Assemble mounting bracket angle to
warning light bracket assembly using 1/2-13
x 1-1/2 hex head cap screws and hex lock
nuts.
3-14.3 Assemble warning light bar and warning
light bracket assembly to outer rear of frame
as shown in Figure 3-16 using 1/2-13 x
5-1/2 hex head cap screws and hex lock
nuts.
IMPORTANT
MAKE SURE LIGHTS ARE POSITIONED FOR
MAXIMUM VISIBILITY FROM THE REAR.
3-14.4 Install the rear warning light harness
between the lights. Note: A 30" extension
is required to one side of rear warning
light harness on 15’F and 25’-6" models.
3-14.5 Install the main warning light harness
by starting at the hitch and routing the har-
ness through the hose loops to the rear
warning light harness.
3-14.6 Insure the harnesses are clear of any
moving parts and secure the harnesses with
tie wraps provided.
3-25
Figure 3-16 Electrical Installation