Landoll D10P Series, Operator'S Manual

Page: 7 / 24

2-1
Chapter 2
Standard Specifications
The D5P/D10P Series Power Ditchers are connected to
the tractor PTO shaft by means of a shielded double
u-joint. The 2-3/16” diameter alloy steel in-put and
out-put shafts are connected by a #80-2 double roller
chain drive. The drive system rotates on four (4) tri-ply
seal ball bearings in a continuous oil bath.
The D5P18A has a 22 tooth in-put sprocket and a 16
tooth out-put sprocket. The D10P18A has a 16 tooth
in-put sprocket and a 22 tooth out-put sprocket. This
combination gives a cutter head speed of 740 RPM on
both models. (D5P18 @ 540 RPM PTO and D10P18 @
1000 RPM PTO.)
The entire drive system is inside a 6”x10” steel case,
easily accessible by two removable end plates.
The cutter head has four (4) heat treated high carbon
steel blades with a cutting diameter adjustable from 18”
to 20”.
The D5P18A Power Ditcher is designed for use on
tractors with 50 to 110 PTO horsepower and 540 RPM
PTO. The D10P18A Power Ditcher is designed for use
on tractors with 80 to 150 PTO horsepower and 1000
RPM PTO.
NOTE
D10P models can be used with 540 PTO tractors by
reversing sprockets and replacing the tractor end PTO
yoke.
Model D5P18A Model D10P18A
Horsepower
Recommendation
For use on tractors with 540 RPM PTO
from 50 to 110 PTO horsepower. For use on tractors with 1000 RPM PTO from
80 to 150 PTO horsepower.
“A” Frame
Category II and III 3-point hitch.
Cutter Head
Adjustable 18” to 20” Features four (4) replaceable high-carbon steel blades. Rotates at
740 RPM.
Chain Drive
Heavy duty, endless #80H roller chain. Shafts 2-3/16” dia. high carbon steel.
Case hardened top sprockets with 22
teeth and bottom sprockets have 16 teeth. Case hardened top sprockets with 16 teeth
and bottom sprockets have 22 teeth.
Shear Bolt
Two - 3/8” dia. grade 8
Universal Drive Shaft
1-3/8”- 6B Spline. Quick coupler connects
to 540 RPM tractor PTO shaft. Shaft is
telescoping and fully shielded. 1-3/8”- 21 Spline. Quick coupler connects to
1000 RPM tractor PTO shaft. Shaft is
telescoping and fully shielded. (Note:
D10PH18A Models use 1-3/4” - 20 Spline
Drive Shaft)
Chain Drive
6” x 10” x 1/4” tubing welded into rigid, one-piece, all-welded main frame