Landoll Coulter Chisel 2112, Operator'S Manual

Page: 40 / 108

3-2 F-1102-0721
ASSEMBLY INSTRUCTIONS
Center Frame Assembly
2112-09-11

WARNING
IMPORTANT
Read all safety precautions at the front of the section
before attempting any of the following procedures.
1. Place center frame assembly on stands
approximately 36” high. The assembly area should
be a large level area of sufficient size to
accommodate the Coulter Chisel when fully
assembled.
2. Remove any shank assemblies or extensions that
may have been turned around or mounted inside the
frame for shipping, and reposition,
See Figures 2-4
through See Figures 2-9 in “STANDARD
SPECIFICATION” section for shank placement.
3. Install the 340/65 R18 tire/wheel assemblies to all
hub/spindle assemblies using 5/8 wheel nuts,
See
Figures 3-2 . Torque to 85-100 ft/lbs.
NOTE
The valve stems will face outwards.
4. Install the 2112 front manifold assembly on 2 hole
plate on front of center frame tube using 1/2 x 4 bolt
and 1/2 lock nut.
5. Attach smv mount, manifold mount to rear tube of
center frame with 5/8 x 6 bolts and 5/8 lock nuts.
6. Install the smv, SIS decal bracket to smv mount with
1/4 x 1 bolts and 1/4 lock nuts. Install the SIS 20mph
decal in location shown
See Figures 3-1 .
Figure 3-1: SIS 20mph Decal Installation
7. Install the 8 port manifold assembly for optional
hydraulic reel attachment on manifold mount using
1/2 x 3-1/2 bolts and 1/2 lock nuts.
Do not attempt to lift heavy parts (such as the
frame, coulter gangs, wheel lift, and pull hitch)
manually. Use a hoist or a forklift to move these
parts into position.
SIS DECAL
MOUNT
SIS 20 MPH
DECAL
LOCATION
SIS 20 MPH
DECAL