Landoll Coulter Chisel 2112, Operator'S Manual

Page: 92 / 108

4-6 F-1102-0721
OPERATION AND MAINTENANCE
Variable Ratio Adjustment
The leveler is equipped with a variable ratio adjustment.
Connect the leveler tube assembly to the middle hole in
the center wheel lift for normal operation
See
Figures 4-4 . This will cause the rear of the machine to
raise higher than the front increasing transport height.
The lower hole on the center lift provides an increased
leveler ratio, which will cause the Coulter Chisel to
become more level in transport. The lower hole should be
used when a rear tow hitch is needed to reduce the
height of the rear tow hitch during transport. The upper
hole on lift provide less leveler ratio, which will cause the
rear of the machine to raise higher than the center hole.
Further increase the rear height.
1. To change the variable ratio adjustment, lower the
implement to the ground and relieve the load on the
lift system.
2. Extend or retract the radius assembly, until the load is
removed from the leveler tower.
3. To adjust the leveler tube weldment at the center
wheel lift, remove the hitch pin, 1” lock nut.
4. Reinstall the hitch pin, 1” lock nut in the leveler tube
assembly to the center lift in the desired position.
Figure 4-4: Variable Ratio Leveler Adjustment
ADJUSTMENT
WRENCHES
2-1/2 JAM
NUTS
HITCH
ASSEMBLY
RADIUS
ASSEMBLY
HITCH PIN,
1” LOCK NUT
ADJUSTMENT HOLES
ON CENTER WHEEL LIFT
LEVELER TUBE
WELDMENT