Landoll BRILLION TURFMAKER II SL, Operator'S Manual

Page: 34 / 100

2-18 9K998
ASSEMBLY
Warning Lamp Installation, 12Ft
NOTE
12Ft 3Pt model is shown, drawbar model similar.
1. Attach both Red Lamps to the ends of the Light Bar
with 1/4-20 x 1-1/4 Bolts and Locknuts.
2. Attach Amber Lamps to the outer ends of the
Seedboxes with 1/4-20 x 1-1/4 Bolts and Locknuts.
3. Attach the Light Module to the Module Bracket with
1/4-20 x 1-1/2 Bolts and Locknuts. See Figure 2-24.
4. Layout the Lamp Harness, noting that the connectors
marked with Green Tape is Right Side and Yellow
Tape is Left Side.
5. Connect the Lamp Harness into the Light Module,
route the plugs with Green Tape along the front right
side of the Frame up the outer end of the Seedbox
and plug the 2 prong cord into the Amber Lamp.
Route the 3 prong cord up the right hand side of the
Light Bracket and plug into the Red Lamp.
6. Repeat for the Left Side (Yellow Tape).
7. Plug the 7 Pin Harness into the Light Module, then
route the Harness along the 3Pt Hitch.
8. Bundle and secure excess cord to the Module
Bracket with Tie Wraps. Secure cords along frame
and 3Pt Hitch using Adhesive Mounts and Tie
Wraps.
NOTE
Install, route and secure Electric Clutch Harness with the
Lamp Harness.
IMPORTANT
All Harnesses must be firmly attached to machine
frame members or hydraulic hoses so they do not
sag or become torn loose by field debris.
9. Attach the SMV sign to the SMV Mount located on
the center on the Light Bar with 5/16-18 x 1 Bolts,
Flat Washers, and Locknuts.
10. Attach the Connector Holder to the 3Pt Hitch with
1/4-20 x 1 Bolts, Flat Washers, and Locknuts.
NOTE
The plug on the other end of the 7 Pin harness connects
to the tractor socket when in use. When not in use, it can
be stored in the Connector Holder on the 3Pt Hitch. Allow
enough Harness length to reach tractor socket and roll or
fold up excess and secure to Hydraulic Hose or 3Pt
Hitch.
Figure 2-24: Light Module and Bracket
0RGXOH
%UDFNHW
/LJKW0RGXOH
/RFNQXW
%ROW
[