Landoll Brillion SCP-111, Operator'S Manual

Page: 7 / 22

973rev401
1J534
DECAL BRACKET
MACHINE
REAR
FRONT
BOLT, 3/4-10 NC x 8”
NUT, 3/4-10 NC
LOCKWASHER 3/4”
LH OUTER SHANK
ASSEMBLY WITH
DECAL BRACKET
FIGURE 2B
6. When assembling the outermost
shank assembly on each side of the
machine, include the decal bracket
containing the red and amber
reflective decals.
These reflective
decals must be visible on any
machine 8 feet wide or more.
The
left hand assembly is shown in
Figure 2B at left. Fasten the bracket
to the top of the plate making sure it
is rotated so that the decals are not
angled with the frame tube but so
that amber is aimed directly forward
and red directly back. Assemble
the right hand outer shank assembly
in the same way.
7. See Page 4 for placement of the BRILLION name decal.
8. Finally, assemble the SUPPORT STANDS through the square tubes on the ends of the frame. Insert
the 1/4 x 2 1/4" long cotter pins in the top holes of the support stands to prevent them from falling out
when the machine is raised. When the machine is idle and not mounted to the tractor, the 1/2 x 3" long
clevis pins, inserted in the middle holes, will prevent the unit from tipping. Then when you raise the machine
for working or for transport, remove the clevis pins, raise the support stands all the way up and insert pins
in the lowest hole. this will keep the support stand up and out of the way while the machine in use.
GENERAL INFORMATION
Shanks: 1" thick, high strength material
Shank Spacing: Designed or 19" or 20" shank spacing
Working Depth: 0 to 16"
Hitch: Pins provided with the 5 shank and 7 shank models are designed to work with Category II three-point
hitch and Category II quick-attaching coupler. Provided with the 9 shank and 11 shank models are pins de-
signed to work with category II and Category III quick-attaching coupler and Category III three point hitch.
Gage Wheels (Optional):15" - 5 bolt, for 6.70-15 tire kit# 8D626
15" - 6 bolt, for floatation tire kit # 1J661
MAINTENANCE
After the first 5 or 6 hours of operation, go over the machine and tighten all nuts with lockwashers which might
be loose and retighten the vertical clamping bolts.
Check shank bolts daily. -Refer to set up instructions for correct tightness.
Normal periodic checks should be made thereafter.
Gage wheel bearings should be packed once each season, if your machine is so equipped.
Page 3-[b]