Landoll Brillion SCP-111, Operator'S Manual

Page: 17 / 22

973rev401
1J534
Page 11-
[3]
Assemble a #4K998 mounting strap to the right side of the machine frame as close to the end
as shanks and gage wheels permit. Use #3J662 strap and 8 1/2” long machine bolts as
illustrated above. Then attach a #4K999 mounting bracket to mounting strap with 1/2” x 1 1/2”
capscrews, flat washers, lockwashers, and nuts. Assemble the other brackets and straps in
similar fashion on the left side of the machine.
Attach lamp assemblies with fasteners shown (amber facing forward; red and amber facing
rearward with amber above red).
Connect “wishbone” wiring harness ends to connectors on lamp assemblies. ( IMPORTANT :
wires are color coded on wishbone harness. Connect end with yellow wire to left
side lamp assembly. Connect end with green wire to right side lamp assembly)
. Run
wishbone harness wires along rear frame member to center of machine.
At center of machine assemble the connector of the straight harness to the wishbone har-
ness. The 7-pin plug on the straight harness connects to the tractor socket when in use. Allow
enough harness length to reach tractor socket and roll or fold up excess. Attach permanently
to implement frame. All wires must be firmly attached to machine frame members so they don’t
droop or become torn loose by field debris. Use plastic cable ties, provided, and electrical tape to
secure all wiring.
#1C267
CAPSCREW 1/2” x 1 1/2”
SUB-SOILER FRAME
REAR
#6J150
LOCKNUT, 1/4”
#1C109 LOCKWASHER
#1C390 HEX NUT, 1/2”
#3J662
STRAP
#4K773 R.H. LAMP
ASSEMBLY (SHOWN)
#4K772 L.H. LAMP
ASSEMBLY (NOT SHOWN)
#4K782
MACHINE SCREW
1/4” x 1 1/4”
#4K937 MACHINE BOLT
#4K998
MOUNTING STRAP
#4K999
MOUNTING BRACKET
#1C120
FLAT WASHER
WARNING LAMP ASSEMBLY