Landoll Brillion M881, Operator'S Manual

Page: 32 / 52

3-2 2K795
OPERATION
Hydraulic Cylinder Hook Up
For instances where the cylinder stays with the tractor,
not the implement;
Install Cylinder : (Machine locked in Raised position)
Remove pin from cylinder base end, attach cylinder base
to front of frame. Remove clevis pin, 1/2 x 2-1/2 and
hairpin from float link to allow it to pivot forward. Remove
pin from cylinder rod end and attach cylinder rod to float
link. Route hoses through hose holder. Attach hose to
tractor couplers if not already done. Raise machine,
disconnect transport lock straps and move to storage
position.
See Figure 3-7. Reinstall float link clevis pin
and hairpin.
If machine is lowered, the only difference is make sure
transport lock straps are in storage position. Ensure 1/2 x
2-1/2 Clevis Pin is locking Float Link
See Figure 3-7.
Remove Cylinder:
Raise machine fully. Attach transport lock straps to hole
in rockshaft lug.
Remove 1/2 inch pin from float link in right side.
Retract cylinder, machine weight should still be
supported by transport lock straps.
Remove cylinder pins and cylinder. Reinstall clevis pin
and hairpin to save for next time. Remove hoses.
Figure 3-1: Float Link
)ORDW/LQN
&\OLQGHU
&OHYLV3LQ
[
+DLU3LQ
5RFNVKDIW/XJ
02S)ORDW/LQN