Landoll Brillion M881, Operator'S Manual

Page: 18 / 52

2-8 2K795
ASSEMBLY
Drawbar Linkage
Insert 2 x 36-1/4 Straps through the front of the Truss and
position a strap on each side of the Rockshaft Lug
bottom hole, secure with 3/4 x 1-7/8 Clevis Pin and
5/32 x 1-1/2 Cotter Pin. Place the springs over the Spring
Guide rods and slide them over the Drawbar Anchor
Plate tubes. Insert the 3/4-10 x 10 Bolt through the
Spring Guide and Drawbar Anchor Plate and screw it into
the yoke. Join the Yoke and the 2 x 36-1/4 Straps with a
2-1/2 x 7-1/4 Strap and 3/4 x 1-7/8 Clevis Pins, secure
with 5/32 x 1-1/2 Cotter Pins.
See Figure 2-7.
When making the final connection, the drawbar may
need to be blocked up a few inches for easier assembly.
Turn the 3/4-10 x 10 Bolt into or out of the yoke to level
the Pulvi-Mulcher.
For tractors with low drawbars , turn the bolt out of the
yoke so that the bolt is just through the yoke.
For tractors with higher drawbars , turn the bolt further
into the yoke.
Most of the Bolt threads will be used when the tractor
drawbar is 20 inches or more above the ground.
Figure 2-7: Drawbar Linkage
02S'UDZEDU/LQNDJH
'UDZEDU
<RNH
6WUDS
[
&OHYLV3LQ
[
&RWWHU3LQ
[
6WUDS
;
&OHYLV3LQ[
&RWWHU3LQ[
%ROW
[
6SULQJ
6SULQJ*XLGH
$QFKRU3ODWH