Landoll 876-30, Operator'S Manual

Page: 57 / 60

TROUBLESHOOTING GUIDE
5-3
ROCKS JAMMING IN END OF REEL
AND LOCKING UP REEL Reel blade too long Cut 1-1/2" off the end of reel blade.
Reel angle wrong for terrain Cut blade off at angle toward rear of blade
to provide a relief area for rocks.
HARROW PLUGGING Improperly set harrow Set according to operating instructions
(See “Harrow Adjustment” on
page 4-7.)
WINGS FOLDING TOO FAST Restrictor elbows not installed Check to make sure restrictors are
installed per assembly instructions.
Idle tractor when folding.
Turn tractor hydraulic flow down.
Engage hydraulic valve. Hold fully
engaged until folded.
MACHINE RUNNING DEEP TO ONE
SIDE Distance from frame to axle of gauge
wheels differ a. Set all depth stops the same.
b. Raise machine until all cylinders are
fully extended.
c. Measure cylinders from pin to pin.
Verify that all cylinders are same
length.
d. If measurements are not the same,
see “Hydraulic Lift Installation
(876-30, 876-35, 876-40-C)” on
page 3-9 and “Hydraulic Lift
Installation (876-40-H)” on page 3-11
to readjust cylinder length.
Wing cylinders may need to vary in length
from main cylinders, per soil conditions.
Check that tires are same size and
pressure is correct.
Check for hydraulic leakage and repair.
CYLINDERS BROKEN IN TRANSPORT Machine not properly secured during
transport Use transport locks and let machine down
on locks during transport (See
“Transport” on page 4-3.)
PROBLEM PROBABLE CAUSE SOLUTION