Landoll 876-30, Operator'S Manual

Page: 41 / 60

ASSEMBLY INSTRUCTIONS
3-25
Warning Lights Installation
1. Assemble lights to the warning light bracket using
1/4-20 X 1-1/4 hex head cap screws and hex lock
nuts. Insure the wires are in the groove in the base of
the light toward the mounting surface on the bracket.
Assemble one light for left side and one for right side.
The red light should be to the rear with the amber
light being the outer most light
(See Figure 3-14.)
2. Install a red reflector and an orange stripe on the rear
side of each warning light bracket.
3. Install a yellow reflector on the front side of each
warning light bracket.
4. Assemble mounting bracket angle to warning light
bracket assembly using 1/2-13 x 1-1/2 hex head cap
screws and hex lock nuts.
5. Assemble warning light bar and warning light bracket
assembly to outer rear of frame as shown in
Figure
3-14 using 1/2-13 x 5-1/2 hex head cap screws and
hex lock nuts.
IMPORTANT
Make sure lights are positioned for maximum
visibility from the rear.
6. Install the rear wiring harness between the lights.
Note: A 30" extension is required to one side on
all models.
7. Install the main harness by starting at the hitch and
routing the harness through the hose loops to the
extension harness.
8. Insure the harnesses are clear of any moving parts
and secure the harnesses with tie wraps provided.