3-12
F-832-2307
Center Frame Tires
Install the tire and wheel assemblies on the center
section.
Disc Gangs
DANGER
DANGER
1.
Attach the disc gang assemblies to the center section
using 3/4-10 x 2 grade 8 hex head cap screws and
hex lock nuts
. Use a 3/4-10 x 2-1/2
grade 8 hex head cap screw, lubrication bracket and
hex lock nut on each center front screws of the left
and right front disk gangs.
2.
21’-29’ models require a 3/4-10 x 8 grade 8 hex head
cap screw, and hex lock nut at the center of the front
gang.
3.
On 30’-36’ models, use 3/4-10 x 3-3/4 and 8 grade 8
hex head cap screws at the center of the front gang.
4.
Insert plastic flange bearings into each end of round
tube ends of the center and wing frame disc gang
assemblies.
5.
Install a 1/2 x 2-1/4 grooved alloy pin in the end of
each hinge pin.
6.
Assemble each wing gang to the center frame gang
using the hinge pin, 1-1/2 thrust washer, 1-1/2 slotted
nut and 3/8 x 2-1/4 spring pin.
NOTE
The thrust washer is positioned on the front side of the
hinge on the front gangs, and on the rear side of the
hinge on the rear gangs.
7.
Place the outer ends of the gang bars on stands so
the wing gangs are level with the center section.
Disc blades are extremely sharp. Exercise
extreme care when working on or near disc
blades. Do not allow discs to roll over or fall onto
any bodily part. Do not allow wrenches to slip
when working near disc blades. Never push
wrenches toward disc blades. Do not climb over
machine above disc blades. Failure to stay clear
of disc blade edges can cause serious personal
injury or death.
