Landoll 6231, Operator'S Manual

Page: 146 / 156

4-20 F-832-2307
TABLE OF CONTENTS
Depth Stop Adjustment (Manual)
The operating depth of the disc is controlled by a
single-point depth stop. The stop is located at the center
front of the machine.
1. Adjust the depth stop by turning the handle in
(clockwise) to increase operating depth
See
Figure 4-22 Turn the handle out (counter-clockwise)
to decrease operating depth. One turn will equal
approximately 3/16” adjustment in depth.
Figure 4-23: Depth Stop Adjustment (Manual)
2. The gauge on the side of the depth stop tube gives a
reference for depth setting. The “A“ setting refers to
maximum operating depth.
IMPORTANT
For maximum operating depth, the lift wheels must
be in contact with the ground and carry some of the
machine weight. Raising the lift wheels off the
ground, permits uncontrolled depth of each frame
section and does not allow the leveler to function
properly. Discing depth and leveling will be
unpredictable and uneven.
DEPTH STOP HANDLE
DEPTH STOP TUBE
DEPTH STOP GAUGE