Landoll 4620-24, Operator'S Manual

Page: 26 / 64

2-10 F-886-0322
ASSEMBLY
TABLE OF CONTENTS
Console w/Clutch Control
Tractor Installation
(Used on models before the Brillion Elite Mini Monitor)
Refer to Figure 2-10 for Clutch and Seed Shaft Sensor
Schematic.
1. Mount Clutch and Seed Shaft Sensor Console Angle
Bracket onto Tractor Bracketry where convenient for
the operator.
See Figure 2-9.
2. Attach Straight Bracket to Angle Bracket using
1/2-13 x 1-1/2 Bolt and Flanged Ny-Lok Nut.
3. Attach the Clutch and Seed Shaft Sensor Console to
the Straight Bracket with 1/4-20 x 1 Bolt, Flat
Washers and Locknut.
4. Plug Clutch and Seed Shaft Sensor Console 3 Pin
Power Cable into the Tractor Convenience Outlet
and 9 Pin Cable into the Seeder Harness.
5. Secure Console Harness.
6. Check clutch operation: Clutch will engage when
power is applied. (Clutch will make a clicking sound).
Set seeder on the ground and drive a short distance
while turning switch on and off. The seed shaft will
stop rotating when switch is turned to “NO SEED”
position.
See “Clutch Operation” on page 3-10.
Figure 2-9: Console w/Clutch Control Tractor Installation
Bolt,1/2-13 X 1-1/2
Angle Bracket
Straight Bracket
Console
Nut,Lock 1/4-20
Washer,Flat 1/4
Bolt,1/4-20 X 1
Washer,Flat 1/4
Nut,Flange
Ny-Lok,1/2-13
4620-24 Monitor
9-Pin Amp
Sensing/Clutch
Control Connector
3-Pin Amp
Power Cable
Convenience Outlet