Landoll 4620-24, Operator'S Manual

Page: 17 / 64

F-886-0322 2-1
TABLE OF CONTENTS
Chapter 2
Assembly
CAUTION
WARNING
CAUTION
The 4620-24 Folding Seeder is almost completely
assembled prior to shipping. If some components need
removed or adjusted follow the below instructions.
NOTE
Refer to the repair parts manual F-885 for identification of
parts and for the approximate relationship of the parts in
assembly.
To ensure alignment of assemblies, leave the nuts loose
until completion of final assembly. Use lock washers or
flat washers as specified. Spread all cotter pins.
After completion of final assembly, tighten all nuts evenly
to prevent misalignment, distortion or binding. Tighten all
screws and nuts to the recommended torques.
IMPORTANT
• If pre-assembled parts or fasteners are temporarily
removed, remember where they go. It is best to keep
parts separated.
• Check that all working parts move freely, bolts are
tight and cotter pins spread.
• Refer to the Torque Table for proper torque valves.
Note the different torque requirements for bolts with
lock nuts.
See Page 5-1.
“Left” and “Right” refer to directions seen as if standing
behind the machine and facing in the direction of forward
travel.
The 4620-24 Folding Seeder Frame comes assembled.
Attach a Seeder Undercarriage Assembly to each Wing
Arm and connect the Wing Lock Hydraulic Circuit. Install
the Brillion Elite Mini Monitor System, Coil Tine Harrows,
and Warning Lamp RH and LH Lamp Brackets.
•
Prepare Tractor for Operation. See “Tractor
Preparation” on page 3-2.
• Prepare Folding Seeder. See “Folding Seeder
Preparation” on page 3-2.
• Attach Folding Seeder to Tractor. See “Attaching
Folding Seeder to the Tractor” on page 3-2.
Do not work on or under this machine unless
securely blocked and supported by a hoist or
tractor or by other sufficient means.
Do not attempt to lift heavy parts manually. Use a
hoist or a fork lift to move these parts into
position.
Secure the Seeder Hitch to a tractor and unfold the
wings of the hitch when attaching seeder unit(s).
This will provide stability and ease attachment of
the seeder unit(s).