Landoll 345D, Operator'S Manual

Page: 25 / 64

OPERATING INSTRUCTIONS
3-13
Figure 3-6: Dock Leveler Controls
Dock Leveler Control
1. To activate the dock level hydraulic circuit, turn the
lever on the driver’s side of the trailer bed near the
front up to the engage position.
2. The DOCK LEVELER CONTROLS are located
under the deck, on the driver’s side, between the
axles
(See Figure 3-6.) The front-most control
adjusts the cylinder on the driver’s or street side of
the trailer. The rear-most control adjusts the cylinder
on the curb-side of the trailer. Both controls have
three positions:
— IN
When the control for either cylinder is pushed in,
toward the center of the trailer, the corresponding
side of trailer is lowered.
— CENTER
This position is neutral for either control. When
either control is in this position, there is no effect
on either cylinder.
— OUT
When the control for either cylinder is pulled out,
away from the center of the trailer, the
corresponding side of trailer is raised.
3. After completion of dock level, turn the lever down to
the disengage position.