3-11 REMOTE CONTROL OPERATION
3-11.1
The
POWER SWITCH
is located on the
top of the box and must be turned on for the
the remote control to operate
(See Figure
3-11.2
The
EMERGENCY KILL
switch is a
button on the top of the box.
a.
Should an emergency situation occur, the
receiver may be shut down by pressing the
EMERGENCY KILL SWITCH
on the transmit-
ter. This must be pressed while the transmit-
ter power is in the on position.
b.
To resume operation, the
POWER SWITCH
must be turned off and back on again.
3-11.3
The
DECK SELECTOR
is in the middle
of the front panel.
LOWER
When the deck selector is in this po-
sition, the functions listed
BELOW
this switch are operational. For the
Front, Rear, and Middle Winch con-
trols, the lower deck winches are op-
erational.
UPPER
When the deck selector is in this po-
sition, the functions listed
ABOVE
this switch are operational. For the
Front, Rear, and Middle Winch con-
trols the upper deck winches are op-
erational.
3-11.4
The remaining switches operate like the
hydraulic controls listed on
Page 3-7
and the
winch controls listed on
Page 3-8.
3-9
Figure 3-4 Remote Control
Summary of Contents for 336C
