9
5.:
Preparation
You will need to purchase a Propane bottle with a 27mm clip on valve to operate this barbecue
which can be obtained from your nearest Gas Retailer.
Energy saving tips:
a.:
Preheat the barbecue for 5 minutes low then 10 minutes on medium.
b.: Do not preheat longer than recommended.
c.:
Do not use a higher setting than required.
6.:
Installation
After purchasing your gas bottle you will then be ready to set it up
with your barbecue.
a.:
Position the gas bottle at the side of your barbecue, not underneath, keeping in mind
that the bottle must be kept away from heat and in a safe position.
b.: When ready to use your barbecue insert the regulator into the gas bottle valve and
tighten firmly.
Note: Before attempting to light your barbecue you must refer to your lighting instructions
and warning / safety points.
Check the hose before each use, searching for cracking, cuts or any abrasions. If the hose is
found to be faulty in any way do not attempt to use your barbecue.
When changing your gas bottle ensure that there are no sources of ignition close by i.e. fires,
cigarettes, naked flames etc. Make sure that the appliance is switched off.
Ensure that the hose is free from any kinks or bends which will affect the gas flow when using
your barbecue. Also the hose must not have undue tension and must not touch any part of
the barbecue which may be hot.
How to change your cylinder
These cylinders take a regulator which incorporates a switch for the on / off control of the
gas supply. No spanner is required.