Operator Manual S755 (G2) / S755 XL (G2)
October 2017
Landis International - 4
ELECTRICAL CONTROL BOX
The electrical control box is in front of the
machine. The motor is thermally
protected. In case of overload, the relay
will trip and shut the motor off. The
overload on the motor must be reset
after a short period of time (see page 25).
GROUNDING INSTRUCTIONS
In the event of a malfunction or breakdown, grounding provides a path of least
resistance for electric current to reduce the risk of electric shock. This tool is
equipped with an electric cord having an equipment-grounding conductor and a
grounding plug. The plug must be plugged into a matching outlet that is properly
installed and grounded in accordance with all local codes and ordinances.
Do not modify the plug provided - if it will not fit the outlet, have the proper outlet
installed by a qualified electrician.
Improper connection of the equipment-grounding conductor can result in a risk of
electric shock. The conductor with insulation having an outer surface that is green
with or without yellow stripes is the equipment-grounding conductor. If repair or
replacement of the electric cord or plug is necessary,
do not connect the equipment-grounding conductor
to alive terminal.
Check with a qualified electrician or service personnel
if the grounding instructions are not completely
understood, or if in doubt as to whether the tool is
properly grounded.
Use only 3-wire extension cords that have 3-prong
grounding plugs,
A
, and 3-pole receptacles that
accept the tool's plug,
B
.
Repair or replace damaged or worn cord immediately.
Make sure the tool is connected to an outlet having the same configuration as the
plug. No adapter is available or should be used with this tool. If the tool must be
reconnected for use on a different type of electric circuit, the reconnection should
be made by qualified service personnel; and after reconnection, the tool should
comply with all local codes and ordinances.
A
B
