LANDA SEA • 8.913-999.0 • Rev. 6/13
25
PRESSURE W
ASHER
OPERA
TOR’S MANU
AL
HaNDHelD WIReleSS OpeRaTINg INSTRUCTIONS
Transmitter/Receiver Communication Set-up at factory
Programming communication between the receiver and transmitter requires the removal of the receiver en-
closure lid. The receiver must ahve 120V power. This process utilizes the Function/Select buttons on the main
panel control board (PCB) of the receiver (See Figure below). A number of colored LED's are used to indicate
various steps in the programming process (See Figure below). It is recommended that this process is not done
while wired to the machine.
Receiver programming leD's and programming Switches
The T60-04CRV receiver programming process is as follows: While programming, make sure there are no other
transmitters are transmitting in the area.
1. Press the
function button once to select the "Learn Code" mode. (#6 Red LED lights, you have approxi-
mately 5 seconds to make the next selection.)
2. Press the
Select button once and then press any button on the transmitter and hold. (#6 Red LED will blink
on/off three times and go out. After releasing the transmitter button, the relays will respond to the appropriate
buttons (Button 1/R1; Button 2/R2; Button 3/R3; Button 4/R4); and the #6 red LED will blink on/off indicating
that one or more adjustable codes have been learned by this receiver.
3. Press and hold the
Select button for 6-8 seconds so the yellow LED is on solid. (#7 Yellow LED lights)
NOTe: This step is only completed when establishing the first transmitter communication.
The receiver is now programmed to the desired transmitter.
Transmitter
button 1
#7 leD
#6 leD
Select
button
function
button
Receiver
