PG SERIES PRESSURE WASHER
OPERATOR’S MANUAL
7
LANDA PG
•
REV. 9/02
Battery
WARNING: Wear eye, hand and skin protection when
handling or connecting battery.
WARNING: Batteries generate explosive gases during
normal battery operation. DO NOT expose the battery
to flame or sparks as these gases may ignite.
WARNING: Battery fluid is highly acidic. If battery fluid
contacts skin or clothing, wash immediately with soap
and water. If battery fluid enters eye, immediately flood
eye with running cold water for at least 15 minutes
and get immediate medical attention.
NOTE: The battery must be capable of accepting ring
terminals.
1. Place battery in battery box (battery not included). Use
a group U1, 12 volt, 30 amp hour battery (garden trac-
tor battery). Select a battery similar to the one in the
picture below for proper fit and installation.
Fuel Valve Lever
ON
OFF
Choke Lever
CLOSED
OPEN
Starter Grip
Engine Switch
6.25"
5.25"
8.00"
OPERATING INSTRUCTIONS
❑
Read engine manual warning and operating instructions.
❑
Pull wand coupler collar
back and insert pressure
nozzle into coupler then
secure by pushing collar
forward to lock.
❑
Turn on water at faucet and squeeze spray gun trig-
ger allowing water to flow until a steady stream
comes out of wand.
❑
Move the fuel valve lever
to the ON position. Turn
the fuel valve lever to the
OFF position after stop-
ping engine.
❑
To start a cold engine,
move the choke lever to
the CLOSED position.
To restart a warm en-
gine, leave the choke
lever in the OPEN po-
sition.
❑
Turn the engine switch to the
ON position.
❑
Open spray gun before pulling
the starter grip.
❑
To start the engine pull
the starter grip lightly
until you feel resis-
tance, then pull briskly.
Return the starter grip
gently.
CAUTION: Pull trigger on spray gun to relieve pres-
sure if machine does not start after one pull of starter
grip.
CAUTION: Small engines may kick back. Do not hold
starter grip tightly in hand.
2. To reduce the possibility of sparking attach the
battery cables in the following order. First attach the
positive battery cable (red) to the positive “+” termi-
nal of battery. Next, attach the negative battery cable
(black) to the negative “—” terminal of the battery.
To disconnect the battery remove the cables in the
opposite order as installed. Install battery box cover
and fasten in place.
