4
PG SERIES PRESSURE WASHER
OPERATOR’S MANUAL
LANDA PG
•
REV. 9/02
WARNING: High pressure spray
can cause paint chips or other
particles to become airborne and
fly at high speeds. To avoid per-
sonal injury, eye safety devices
must be worn.
8. Eye safety devices and foot pro-
tection must be worn when us-
ing this equipment.
9. High pressure developed by these machines will
cause personal injury or equipment damage. Use
caution when operating. Do not direct discharge
stream at people, or severe injury or death will re-
sult.
10. Never make adjustments on machine while in op-
eration.
11. Do not operate with spray gun in the off position for
extensive periods of time as this may cause dam-
age to the pump.
12. The best insurance against an accident is precau-
tion and knowledge of the machine.
13. Landa will not be liable for any changes made to our
standard machines, or any components not pur-
chased from Landa.
14. Read engine safety instructions provided.
WARNING: Keep water spray
away from electrical wiring or fa-
tal electric shock may result.
15. Never run pump dry or leave
spray gun closed longer than 5
minutes.
16. To reduce the risk of injury,
close supervision is necessary
when a machine is used near
children. Do not allow children to operate the pres-
sure washer.
This machine must be attended dur-
ing operation.
17. Inlet water supply must be cold and clean fresh wa-
ter.
PRE-OPERATION CHECK
❑
Check pump oil level. (Use SAE 30W non-detergent
oil). Dipstick is located on top of pump.
❑
Cold water supply (minimum 6 gpm, 5/8", 20 psi)
❑
Hose, wand, nozzle (nozzle size per serial plate)
❑
Water filter (intact, non restrictive)
❑
Fuel (unleaded 86 or higher octane)
❑
Open spray gun to relieve pressure before starting.
❑
Engine oil (SAE 10W30)
SET-UP PROCEDURES
❑
Attach a 5/8" garden hose to inlet connector. Mini-
mum flow should be 6 gpm.
❑
Attach high pressure hose to discharge nipple using
quick coupler. Lock coupler securely into place by
pulling back coupler collar and inserting it onto dis-
charge nipple, then pushing collar forward to lock in
place. (Also see pages 6 or 7).
❑
Attach variable pressure wand to spray gun using
teflon tape on threads to prevent leakage.
❑
Attach swivel connector on discharge hose to spray
gun using teflon tape on threads.
❑
Remove oil plug on top of pressure washer pump
and replace with dipstick supplied. (This may be
installed from the factory.)
❑
Check oil level on sight glass on back of pump. Oil
should be visible one half way up sight glass (30W
non-detergent).
❑
Fill gasoline tank and check engine oil.
❑
Notice:
Running the engine with a low oil level can
cause engine damage.
WARNING
PROTECTIVE
EYEWEAR AND
CLOTHING MUST BE
WORN.
WARNING
KEEP WATER SPRAY
AWAY FROM
ELECTRICAL WIRING.
Pressure Hose
Garden
Hose
Inlet
Connector
Collar
Discharge
Nipple
Filter
Filler Cap/Dipstick
Upper Limit
Lower Limit
Sightglass
Dipstick
