Operations
Assembly & Operation
Instructions
STOP!
Read operator’s manual
before operating this machine.
Failure to read operation and
warning instructions may result in
personal injury or property
damage.
STEP 3:
Attach wand to spray gun
using teflon tape on threads to
prevent leakage. Attach the high
pressure hose to the spray gun
using teflon tape on hose threads.
Move safety latch into locked
position.
STEP 1:
Machines must be
stored indoors when not in use.
Location of machine is important.
Avoid installing near combustible
material or in poorly ventilated
areas. Electrical connection to
machine should be the proper
voltage, phase and amperage
(refer to serial plate for informa
-
tion). Plug the power cord into a
grounded receptacle
, then push
in the GFCI reset button.
STEP 4:
Pull the spring-loaded
collar of the wand coupler collar
back to insert your choice of
pressure nozzle.
CAUTION: Never replace nozzles
without engaging the safety latch
on the spray gun trigger.
ATTENTION:
Ne jamais remplacer
les buses sans d'abord mettre le
dispositif de sécurité sur la
détente du pistolet pulvérisateur.
ADVERTENCIA: Nunca reemplace
las boquillas sin asegurar el
candado de seguridad en la
pistola pulverizadora.
STEP 2:
Connect high pressure
hose to discharge nipple by sliding
quick coupler collar back. (If
detergent is to be applied, insert a
detergent injector.) Insert quick
coupler onto discharge nipple and
secure by pushing quick coupler
collar forward.
STEP 5:
Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure
it is seated properly.
IMPORTANT: If the pressure
washer has not been used for an
extended period of time, remove
the nozzle from the end of the
wand and turn on water supply.
Allow water to run from the end
of the wand until clear.
Landa 2HOT Series Operator’s Manual -
9.808-353.0
- A
High
Pressure
Hose
Discharge
Nipple
Coupler
Collar
Detergent
Injector
Safety
Latch
High
Pressure
Hose
Spray
Gun
Wand
Pressure
Nozzle
Wand Coupler
Collar
Pressure
Nozzle
11
