![background image](http://html1.mh-extra.com/html/land-pride/wc1503/wc1503_operators-manual_673000030.webp)
Section 3: Adjustments
11/15/19
26
Section 3:
Adjustments
Adjustment Safety
DANGER
!
To avoid serious injury or death:
Always disengage power take-off before lifting implement up,
and never operate implement in the raised position. Objects
can be thrown at high speeds toward people or animals
Skid Extension Height
Refer to Figure 3-1:
1. Make sure power take-off is disengaged, gear
selector is in park, and park brake is set. Adjust
tractor 3-Point up or down until driveline is close to
level.
2. Place support blocks under the chipper but not under
the skid extensions (#1) to keep the chipper from
drifting down while adjusting the skid extensions.
3. Lower Wood Chipper onto the support blocks, shut
tractor engine off, and remove switch key.
4. Remove hex flange locknuts (#3) and bolts (#2).
5. Lower skid extensions (#1) to the ground and reinsert
1/2"-13 GR5 cap screws (#2). Secure cap screws
with existing hex flange locknuts (#3). Tighten
locknuts to the correct torque.
6. Raise tractor 3-Point up and remove support blocks.
7. Lower unit until resting on its skid extensions.
Discharge Chute Angle
Refer to Figure 3-2:
DANGER
!
To avoid serious injury or death:
Adjust discharge chute to direct material away from operator,
people, animals, equipment, and buildings. The Wood Chipper
1. Push down on rotation chute lock lever (#2) and hold.
2. Rotate discharge chute (#1) in small increments until
desired angle of discharge is achieved.
3. Release rotation chute lock lever (#2). Make sure
lever has locked into position and chute cannot
rotate.
The Wood Chipper operates best if
skid extensions are adjusted to support the unit with
driveline operating near level. This setting will also
increase the life of the driveline u-joints.
NOTE:
This effects loading height for wood.
NOTE:
Chute is limited to 270
o
rotation so as not to
get into loading area.
Adjust Skid Extension Height
Figure 3-1
Adjust Discharge Chute Angle
Figure 3-2
35256
35254